Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 126)

114 Installation & Setup Guide
Rotate Acceleration Rate
This parameter allows the operator to set the acceleration rate for smooth and stable movement of
the contoured bevel head. The higher the acceleration rate, the quicker the Rotate Axis will get up to
speed. The lower the acceleration rate, the smoother the machine will position the cutting device.
Values are entered in Rev/ Sec^2.
Maximum Rotate Speed
Enter the maximum speed for the Rotate Axis rotation in RPM.
Rotate High Jog Speed
Enter a value for the desired Rotate Axis High Jog Speed.
Rotate Low Jog Speed
Enter a value for the desired Rotate Axis Low Jog Speed.
Tilt Acceleration Rate
This parameter allows the operator to set the acceleration rate for smooth and stable movement of
the contoured bevel head. The higher the acceleration rate the quicker the Tilt Axis will get up to
speed. The lower the acceleration rate the smoother the machine will position the cutting device.
Values are entered in Rev/ Sec^2.
Maximum Tilt Speed
Enter the maximum speed for the Tilt Axis in RPM.
Tilt High Jog Speed
Enter a value for the desired Tilt Axis High Jog Speed.
Tilt Low Jog Speed
Enter a value for the desired Tilt Axis Low Jog Speed.