Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 237)

Appendix J: Speed Pot and Joystick 225
Appendix J: Speed Pot and Joystick
Speed Pot and Joystick Overview
Through the use of Single Ended Inputs to an optional Analog Input Card installed in the control, your
shape cutting control may be configured to support an external Joystick or Two Speed
Potentiometers. Note: These features are not available for all control types and optional control
hardware is required.
The external Joystick is used as a directional command signal when in manual motion.
The optional Speed Pot may be used to adjust the current motion speed.
These features must first be enabled at the password protected I/O screen for use.
Analog Card I/O