Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 154)

142 Installation & Setup Guide
Unsupported EIA Codes ( cont. )
EIA CODE
DESCRIPTION
G277 External Variable Load
G278 X Axis Home
G279 Y Axis Home
G280 X Home Return
G281 Y Home Return
M22
PLC Control Code
M75 PLC Control Code
M210 X Sign Toggle
M211 Y Sign Toggle
M212 X and Y Swap and Toggle
M231 Aux. State Reset
M261 Aux. Torch Master On
M262 Aux. Torch Master Off
The unsupported EIA codes previously noted are ignored when read. Some of these codes may be
supported in the future. Any EIA codes that are not listed above will result in a translator error upon
loading the EIA program. Known EIA codes that will not be accepted include, but are not limited to:
Pvalue Program Number
Dvalue Indexed Kerf Operations
Vvalue Internal Variable Load
EIA Comments
Comments may be placed into the part program to be displayed on screen and viewed by the
operator. The comment line must first be preceded by a program stop command (EIA M00 code or
ESSI 0 code).
EIA Example:
M00 – Pauses Program
(Comment) – Text to be displayed