Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 205)

Appendix E: Voyager™ II Machine Interface 193
Series 2 Analog/ PWM Interface Card
Note: The Analog Card will be designated as Rev A in the Control Information Diagnostic screen.
Board Marking PC-026-500 Rev.
Part # PCBS-0040
J5 - I/O
Pin #
Designation Description
1 Joystick IN1 Joystick Up ( single ended – active by E-ground )
2 Joystick IN2 Joystick Down ( single ended – active by E-ground )
3 Joystick IN3 Joystick Left ( single ended – active by E-ground )
4 Joystick IN4 Joystick Right ( single ended – active by E-ground )
5 E Ground Joystick Common
6 Chassis Ground Shield
7 Analog In 6 + Speed Pot 1 +
8 Analog In 6 - Speed Pot 1 –
9 Chassis ground Shield
10 Analog In 12 + Speed Pot 2 +
11 Analog In 12 - Speed Pot 2 –
12 Chassis Ground Shield
Mating Connector
12C Phoenix Connector – Phoenix Part # 1803675
J6 - APC 2
J7 - Plasma 2
Pin # Description Pin # Description
1 Analog In 8 + 1 Analog 7 In +
2 Analog In 8 - 2 Analog 7 In -
3 Shield 3 Shield
4 Analog In 9 + 4 Output 41
5 Analog In 9 - 5 No Connection
6 Shield 6 Input 9
7 +24VDC 7 +24VDC
8 Analog In 10 + 8 No Connection
9 Analog In 10 - 9 Analog Out 2 +
10 Shield 10 Analog Out 2 -
11 Analog In 11 + 11 Chassis Ground
12 Analog In 11 - 12 Output 42
13 Shield 13 Output 43
14 +24VDC 14 Output 44
15 Output 16 15 Output 45
16 +24VDC 16 Output 46
17 PWM 4 + 17 Output 47
18 PWM 4 - 18 Input 41
19 Shield 19 Input 42
20 PWM 5 + 20 Input 43
21 PWM 5 - 21 Input 44
22 Shield 22 +24 VDC
23 PWM 6 + 23 +24 VDC
24 PWM 6 - 24 +24 V Common
25 Shield 25 +24 V Common