Hypertherm HTA Rev 6.00 Install Guide - Manual (Page 179)

Appendix D: Edge™ Machine Interface 167
Appendix D: Edge II™ Machine
Interface
The Edge II™ shape cutting control is an extremely versatile product, offering up to four configurable
axes of motion, configurable I/O locations and three different styles of external table interface for
ease of installation. The control features may also be expanded through use of optional analog and
network interface cards.
Rear Panel Layout
The rear panel of the control has several cable connectors to connect the control to power, I/O and
communication ports. These connectors are clearly labeled as to their function, as shown below.
The AC power cable is inserted into the AC power connector and plugged into a standard 3-way 110
or 220 volt outlet. The control has a universal AC input power module that allows the user to plug into
either voltage without changing additional jumpers. In addition, the AC Power connector contains an
integral fuse receptacle and line filter.
The rear panel has an integrated hinged door to assist in servicing the unit. A remote
communications link can be connected to one of the two serial ports and an external ground (PE) lug
is also provided.