Compuprint 4247-Z03 - Manual (Page 73)

Chapter 5. Attachment Options
This chapter describes the procedures for setting your printer attachment. Your
printer is capable of attaching individually through the following attachment
interface options:
v Bidirectional IEEE 1284 Parallel
v Serial RS232/C 9-Pin
v USB 2.0
v ASCII Ethernet 10/100 BaseT LAN
v ASCII-IPDS Ethernet 10/100 BaseT LAN
The attachments you have depend on what you requested at the time you placed
your order for the printer. To change or check the attachment selection, follow
these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO (down) until the printer
displays
CONFIGURATION MENU
Attachment
3. Press ENTER.
The printer displays
Attachment
* xxxxxx
Where xxxxxx (depending on your currently selected attachment) can be Hot
Port Switch, Parallel, Serial, USB, LAN ASCII, or LAN IPDS.
4. Press SCROLL/MICRO or SCROLL/MICRO until the desired value is
displayed.
5. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
6. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
57