Compuprint 4247-Z03 - Manual (Page 50)

If you specify Immediate Eject for Continuous Forms Eject Mode parameter
(default value) in the Printer Setup category, press LOAD/EJECT to immediately
make the printer not ready. The printer displays:
003 FORMS EJECTED
PRESS LOAD
and advances the form so that you can tear off the form at the perforation and
remove it from the printer.
If you specify Delayed Eject for the Continuous Forms Eject Mode parameter in
the Printer Setup category, press LOAD/EJECT to cause the printer to display:
093 EJECT PENDING
and beep the alarm. When the end of the form is reached, the printer becomes
not ready, displays:
003 FORMS EJECTED
PRESS LOAD
and advances the form so that you can tear off the form at the perforation and
remove it from the printer.
Pressing the key a second time moves the next form to be printed back to the
previous print position and makes the printer ready.
Refer to “Continuous Forms Eject Mode” on page 114 for more information on
changing Continuous Forms Eject mode.
v Ejects forms for viewing
If a Form Feed is not done prior to pressing LOAD/EJECT, the forms will be
positioned for you to view them to examine the printing
FORM FEED
This key advances the forms so that the next form is at the top of form position.
The Form Feed function is available when the printer is not ready.
v If you interrupt a print job by pressing STOP, pressing FORM FEED, and then
pressing START (when you are ready to resume the job), the printer continues
to print on the next form at the place where printing was interrupted on the
previous form.
v If FORM FEED is pressed during load operation, the FORM FEED functions as
a LOAD/EJECT and performs an automatic load.
v The printer does not always have to be not ready before pressing FORM FEED.
See “Form Feed Mode” on page 110 for more information.
SET TOP OF FORM
This should only be used when printing occurred and no Top-of-Forms commands
have been passed to the printer (such as Form Feed or Printer initialization).
34 User's Guide