Compuprint 4247-Z03 - Manual (Page 130)

Continuous Forms Eject Mode
You can set Continuous Forms Eject Mode value to:
v
Immediate Eject (Default)
v Delayed Eject
Selecting Delayed Eject causes the printer to wait until the end of the current page
is reached before forms are moved to the tear off position. For more information,
see “LOAD/EJECT” on page 33.
To change or check Continuous Forms Eject Mode:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Setup
Forms Eject Mode
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Continuous Forms Eject Mode is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Bar Code Print Direction
You can set the Bar Code Print Direction to:
Unidirectional Causes the printer to print in only one direction,
either from left to right or from right to left, for
each of the two passes of bar code printing on a
line.
Bidirectional (Default) Causes the printer to print as the printhead moves
in both directions. (This setting causes faster
throughput but may affect print quality. Verify that
the print quality is acceptable before running a
print job.)
To change or check the bar code print direction, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
114 User's Guide