Compuprint 4247-Z03 - Manual (Page 45)

v The printer receives a command from the host to turn on the alarm
v An invalid key press is attempted
v The SET TOP OF FORM key is pressed
To turn a beeping alarm off, press STOP. You can disable the audible alarm. See
“Alarm Control” on page 68 for instructions.
Note: Pressing SET TOP OF FORM and some attention conditions sound the
alarm, even if it is disabled.
Custom set In-Use indicator
This indicator shows the parameter custom set that is currently being used by the
printer. The indicator is located in the top right corner of the operator panel. A
custom set is a set of configuration values that have been defined at the operator
panel and saved under a letter ID. When the custom set identified by this ID is
selected from the operator panel, these configuration values are used by the
printer.
NOT READY
The current custom set in use is displayed in parentheses . Where can be:
A (Custom Set A in use)
B (Custom Set B in use)
C (Custom Set C in use)
D (Custom Set D in use).
E (Custom Set E in use)
F (Custom Set F in use)
G (Custom Set G in use)
H (Custom Set H in use).
If a change was made in the configuration menu and not saved in a custom set,
then the change is temporary and a blank < > is displayed in the parentheses. For
more information on Custom Sets, see Chapter 4, “Configuration storage,” on page
49.
Function keys
There are 14 keys available on the operator panel for performing printer functions.
These keys perform general printer functions (for example, adjusting forms) and
are used to scroll through and select items in the Configuration Menu and
Operator Print Tests menu.
The following section describes each of the printer function keys on the operator
panel.
Chapter 2. Understanding the operator panel 29