Compuprint 4247-Z03 - Manual (Page 49)

The forms path selected by PARK/PATH also becomes the current value for Paper
Source in the Printer Setup category. See “Paper Source” on page 107.
LINE FEED
This function is valid only when the printer is not ready.
Press LINE FEED to cause the printer to advance the forms one print line, based
on the current LPI setting. If you hold LINE FEED more than four seconds, the
forms move continuously until you release the key.
Similar to the forms advance knob on other printer products, the LINE FEED key
allows coarse vertical movement of forms. This key does not function as an
“Index” key, which may be found on other printer products.
Note: If you use this key when the PROCESSING indicator is blinking, the top of
form position could become misaligned.
LOAD/EJECT
The LOAD/EJECT function depends on what active form path you have selected.
This section describes the function for each of the paper paths.
The LOAD/EJECT key performs the following functions:
v Automatically loads forms
After the forms are loaded under the sensor and onto the tractors at the bottom
of the forms device press LOAD/EJECT to automatically load the forms to the
top of form position.
v Moves forms to the tear-off position
Do not press STOP first.
If a Form Feed is done, either by data stream command or by pressing FORM
FEED
, prior to pressing LOAD/EJECT, the forms will be positioned for you to
tear off the forms at a perforation.
Note:
If pressing LOAD/EJECT did not align the forms perforation with the tear
bar, check the following:
1.
Assure that a Form Feed has been done just prior to pressing
LOAD/EJECT
.
2. Verify that the Tear Position value for the path you are using (Front or
Rear) in the Printer Adjustments section of the Configuration Menu
has been set correctly. Often this value is the negative of the Paper
Load Position value. Adjust the Tear Position to give the best
alignment of the forms perforation to the tear bar edge. Each path has
its own set of adjustment values. When you change these values,
ensure that you are setting the values for the desired path.
Chapter 2. Understanding the operator panel 33