Compuprint 4247-Z03 - Manual (Page 129)

7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Automatic Restore
This parameter is displayed for the Front Push or Rear Push forms path. You can
set the printer to perform an automatic load without pressing LOAD/EJECT.
You can set this value to:
Disabled (Default) No automatic load. The LOAD/EJECT is required
to load forms.
Data An automatic load occurs each time a new print
job is received.
Timer (10 to 50 seconds) An automatic load with a fixed timeout value.
When forms are ejected, a load function is
performed after a timeout. The timeout value can
be 10 seconds, 20 seconds, 30 seconds, 40 seconds,
or 50 seconds.
To change or check the automatic restore, follow these steps:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Setup
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Setup
Automatic Restore
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Automatic Restore is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
The Automatic Restore function can be enabled regardless of the status of the
Automatic Eject function. Automatic Restore can be enabled even if Automatic
Eject is not enabled.
Chapter 8. Printer Setup 113