Compuprint 4247-Z03 - Manual (Page 136)

Front Automatic Forms Thickness Adjustment (AFTA)
This parameter allows you to adjust the distance between the paper and the
printhead for the front forms path. Forms must be loaded for this adjustment to be
effective. This adjustment can be set to one of the following values:
-5 to +3 The printer automatically adjusts the distance
between the forms and the printhead. Each
adjustment corresponds to 0.03 mm (.0012 in.).
(The default is 0, which corresponds to a gap of
0.25 mm [.01 in.] from the forms.)
Fixed 1 to 8 Selects a fixed printhead distance value from 1 to
8, in increments of 0.5 (where each value equals
approximately 0.05 mm [.002 in.]).
Default = 0
To change or check the Front AFTA:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Adjustments
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Front AFTA
5. Press ENTER to display the current value.
6. Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
front AFTA is displayed.
7. Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
8. Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Front Tear Position
You can adjust the front tear position for forms loaded in the front forms path
from -390 to +30 (where each unit is 0.176 mm [1/144 in.]). The default value is 0.
To change or check the Front Tear position:
1.
Press MENU.
2. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
Printer Adjustments
3. Press ENTER.
4. Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Printer Adjustments
Front Tear Position
120 User's Guide