Select-in – Compuprint 4247-Z03 User Manual
Page 109
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Parallel Interface
5.
Press ENTER.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Parallel Interface
Input Buffer Size
7.
Press ENTER to display the current value.
8.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Input Buffer Size is displayed.
9.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
10.
Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Select-In
This parameter is valid in Epson-FX emulation mode only and instructs the printer
how to handle Select-In Signals. You can set the Select-In Signal to:
Disabled
The Select-In Signal is ignored and treated as always on.
Enabled
(Default)
The printer checks the Select-In Signal from the host.
To change or check the Select-In Signal:
1.
Press MENU.
2.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
CONFIGURATION MENU
ASCII Configuration
3.
Press ENTER.
4.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
ASCII Configuration
Parallel Interface
5.
Press ENTER.
6.
Press SCROLL/MICRO or SCROLL/MICRO until the printer displays
Parallel Interface
Select-In
7.
Press ENTER to display the current value.
8.
Press SCROLL/MICRO or SCROLL/MICRO until the desired value for
Select-In Signal is displayed.
9.
Press ENTER.
An asterisk (*) will be displayed in front of the selected value.
10.
Press START or RETURN to exit the Menu. See “Exiting the configuration
menu” on page 39.
Chapter 7. ASCII Configuration
93