BrightSign BrightAuthor User Guide v.4.1.1 - Manual (Page 88)

80 Chapter 4 – Making a Presentation Interactive
• Increment: Specifies how much the volume level increases with each interaction. Select the Analog, HDMI, or
SPDIF connector in the dropdown list.
• Decrement: Specifies how much the volume level decreases with each interaction. Select the Analog, HDMI, or
SPDIF connector in the dropdown list.
• Mute: Turns the connector audio output off. Use the checkboxes to select among the Analog, HDMI, and SPDIF
connectors.
• Unmute: Turns the connector audio output on. Use the checkboxes to select among the Analog, HDMI, and SPDIF
connectors.
Zone Volume: Sets the volume for a zone. Note that the Connector Volume command takes precedence over the Zone
Volume command when both are active in a presentation.
• Set: Specifies an absolute volume level for a zone. Use the dropdown menu to select the zone to which this
command applies and enter a volume value between 0 and 100.
• Increment: Specifies how much the volume level increases with each interaction. Use the dropdown menu to
select the zone to which this command applies and enter an increment amount.
• Decrement: Specifies how much the volume level decreases with each interaction. Use the dropdown menu to
select the zone to which this command applies and enter a decrement amount.
Send: Sends information using the following methods:
• Send Zone Message: Triggers a Zone Message event with the same command parameter as the Send Zone
Message command.
• UDP: Sends a command to the device using UDP protocols.
• Send IR Remote: Sends a command via the 3.5mm IR Out port (4K and XD models only).
• Send IR Remote (Pronto): Sends a command using Pronto Hex Code (PHC) via the 3.5mm IR Out port (4K and
XD models only).
• Send string (EOL): Sends the specified string to the specified serial port. This command adds a carrier return at
the end of the string.