Led indicators – ATEIS DIVA8G2 User Manual

Page 87

Product Features

high quality directive signal pick up from the user and hence less interference from the surroundings.

Hold LED:

These LEDs Indicate which keys are selected.

Busy LED:

Show the status of zone.

Talk Indicator:

This LED light up if it is allowed to paging, on the other word, the paging request has been
acknowledged. Sometime after paging request is granted, zones under paging still can be occupied
by other sources. In such a case, the talk led still light up, but you can check busy LED to know
the situation.

Talk Key:

Push this key to request paging.

Fault LED:

To display fault status of system.

EVAC LED:

"Plug-in" make audio processor to recognize the peripheral devices.

Power LED:

This LED light up when the PPM AS is powered on.

Event Select Key:

These buttons are used to select keys, each key may link to an event for triggering actions like
paging or adjust the value of parameters.

All/Release LED:

This indicator lights up if all keys are selected.

All/Release Button:

This button is used to select or deselect all keys.

4.2.2.3

LED Indicators

Status

POWER

EVAC

FAULT

BUSY

HOLD

Inserting power supply

Continuous

Continuous Scrolling once Scrolling once

Display firmware's version

(EX: v4.7)

Continuous

4 LEDs blink

once

7 LEDs blink

once

Lost communication with Audio

Processor

Slowly

scrolling

Slowly

scrolling

Communicate with Audio

Processor successfully

Continuous

Goes off after

seconds

Goes off after

seconds

Stored in software

Continuous

Continuous Scrolling once Scrolling once