Managing music sources, Messages and microphone calls – ATEIS DIVA8G2 User Manual
Page 71
Product Features
71
© 2012 ATEÏS
4.1.1.9.7 Managing Music Sources
On DIVA front panel, you have the possibility to assigned music sources to a zone (or multiple), set up
attenuation for each speaker zone (only on music).
To manage music source, the music sources should be set in "Route Key" mode, see
The procedure to assign a music source to a zone is the following:
Select the music source:
o
Press the SELECT button to go from Source 1 to Source 2.
o
Press SELECT button to go from Source 2 to no selection.
o
Press SELECT button to re-select Source 1.
Select the zone(s):
o
Press the zone button(s) you want to activate on Master and/or Slaves. The corresponding
white selection LED(s) should light(s) up.
Validate the routing by pressing the ROUTE button.
Zone attenuators:
In each master zone, the music level can be attenuated depending your needs. The attenuators offer 6
attenuation positions: 0, -4, -8, -12, -16, -20 dB.
Adjust the corresponding zone(s) ATTENUATOR KNOBS to the desired attenuation level.
Note: Zones that are monitored cannot be attenuated to -20dB without causing monitoring
problems. At -20dB attenuation, the accuracy of the impedance circuitry reach its limit.
Note: If two music sources are used, keep in mind that attenuator will only have effect on only
one of them (music 1). Because the Voice amplifier will be used for music 2, the attenuators
won't have any effect on the sound level.
Note: Music attenuator are only available on Master DIVA unit.
4.1.1.9.8 Messages and Microphone Calls
From the front panel, you have the choice two start three different messages or do a zone call with the
fireman microphone. Read the following two chapters for more information about
configure the Fireman Microphone
There are three front panel message buttons plus one reset button:
EVAC: initiates a evacuation message broadcasting process.
ALERT: initiates a evacuation message broadcasting process.
MSG TEST: initiates a evacuation message broadcasting process.
RESET: initiate a software reset process.
Messages