Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 86)

Pin Assignments
MVME51005E Single Board Computer Installation and Use (6806800A38D) 88
6.2 Jumper Settings
The following table provides information about the jumper settings associated with th
MVME5100 Single Board Computer. The table below provides a brief description of each
jumper and the appropriate setting(s) for proper board operation.
Jumper Description Setting Default
J1 RISCWatch Header None (Factory Use Only) N/A
J2 PAL Programming Header None (Lab Use Only) N/A
J4 Ethernet Port 2 Selection
(set in conjunction with
jumpers J10 and J17) For “P2” Ethernet Port 2:
Pins 1,2; 3,4; 5,6; 7,8 (set
for 712/761) No
Jumper
Installed
(front panel)
For “Front Panel”
Ethernet Port 2:
No Jumpers Installed
J6, J20 Operation Mode
(Set Both Jumpers) Pins 1,2 for PMC Mode PMC
Mode
Pins 2,3 for SBC Mode
(761 Mode)
J7 Flash Memory Selection
at Boot Pins 1,2 for Soldered Bank
A Socketed
Bank B
Pins 2,3 for Socketed
Bank B
J10, J17 Ethernet Port 2 Selection
(set in conjunction with
jumper J4 For “Front Panel”
Ethernet Port 2:
Pins 1,3 and 2,4 on Both
Jumpers Front
Panel
Ethernet
Port 2
For “P2” Ethernet Port 2:
Pins 3,5 and 4,6 on Both
Jumpers (set for 712/761)