Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 71)

Functional Description
MVME51005E Single Board Computer Installation and Use (6806800A38D) 73
The SBC mode (also called 761 or IPMC mode) are backwards compatible with the
corresponding MVME712 and MVME761 transition cards and the P2 adapter card (excluding
PMC I/O routing) used on the MVME2600/2700. The SBC mode is accomplished by configuring
the on-board jumpers and attaching an IPMC712 or IPMC761 PMC in PMC slot 1 of the
MVME5100.
PMC mode is backwards compatible with the MVME2300/MVME2400. PMC mode is
accomplished by simply configuring the on-board jumpers.
Note: Refer to Chapter 6, Pin Assignments for P2 Input/Output Mode jumper settings.
4.3.6 Input/Output Interfaces
The following subsections describe the major I/O interfaces on the MVME5100 including
Ethernet, VMEbus, asynchronous communications ports, real-time clock/NVRAM/Watchdog
Timer, other timer interfaces, interrupt routing capabilities and IDSEL routing capabilities.
4.3.6.1 Ethernet Interface
The MVME5100 incorporates dual Ethernet interfaces (Port 1 and Port 2) via two Fast Ethernet
PCI controller chips.
The Port 1 10BaseT/100BaseTX interface is routed to the front panel. The Port 2 Ethernet
interface is routed to either the front panel or the P2 connector as configured by jumpers. The
front panel connectors are of the RJ45 type.
Every board is assigned two Ethernet Station Addresses. The address is $0001AFXXXXX where
XXXXX is the unique number assigned to each interface. Each Ethernet Station Address is
displayed on a label attached to the PMC front-panel keep-out area.
In addition, LAN 1 Ethernet address is stored in the configuration area of the NVRAM specified
by the Boot ROM and in SROM.
4.3.6.2 VMEbus Interface
The VMEbus interface is provided by the Universe II ASIC. Refer to the Universe II User’s Manual,
as listed in
Appendix D, Related Documentation , for additional information.