Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 11)

MVME51005E Single Board Computer Installation and Use (6806800A38D) 15
About this Manual
Overview of Contents
The MVME51005E Single Board Computer Installation and Use provides the information you will
need to install and configure your MVME51005E Single Board Computer. It provides specific
preparation and installation information and data applicable to the board. The MVME51005E
will hereafter be referred to as the MVME5100.
The MVME5100 is a high-performance VME single board computer featuring the PowerPlus II
architecture with a choice of processors—either the MPC7410 with AltiVec
™
technology for
algorithmic intensive computations or the low-power MPC750.
As of the printing date of this manual, the MVME5100 is available in the configurations shown
below. Note: all models of the MVME5100 are available with either VME Scanbe front panel or
IEEE 1101 compatible front panel handles.
Model Number Description
450MHz MCP750 Commercial Models
MVME51005E-016x 450MHz MCP750, 512MB ECC SDRAM, 17MB Flash and
1MB L2 cache.
400 and 500 MHz MPC7410 Commercial Models
MVME51105E-216x 400MHz MPC7410, 512MB ECC SDRAM, 17MB Flash and
2MB L2 cache.
MVME51105E-226x 500 MHz MPC7410, 512MB ECC SDRAM, 17MB Flash and
2MB L2 cache
MVME712M Compatible I/O
IPMC7126E-002 Multifunction rear I/O PMC module; 8-bit SCSI, Ultra
Wide SCSI, one parallel port, three async and one
sync/async serial port.
MVME712M6E Transition module connectors: One DB-25 sync/async
serial port, three DB-25 async serial ports, one AUI
connector, one D-36 parallel port, and one 50-pin 8-bit
SCSI; includes 3-row DIN P2 adapter module and cable.
MVME761 Compatible I/O
IPMC7616E-002 Multifunction rear I/O PMC module; 8-bit SCSI, one
parallel port, two async and two sync/async serial ports.