Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 50)

PPCBug Firmware
MVME51005E Single Board Computer Installation and Use (6806800A38D) 52
ROM Boot Enable [Y/N] = N?
ROM Boot at power-up only [Y/N] = Y?
ROM Boot Enable search of VMEbus [Y/N] = N?
ROM Boot Abort Delay = 5?
The time (in seconds) that the ROMboot sequence will delay before starting the boot. The
purpose for the delay is to allow you the option of stopping the boot by use of the BREAK key.
The time value is from 0-255 seconds. (Default = 5 seconds)
ROM Boot Direct Starting Address = FFF00000?
The first location tested when PPCBug searches for a ROMboot module. (Default =
0xFFF00000)
ROM Boot Direct Ending Address = FFFFFFFC?
The last location tested when PPCBug searches for a ROMboot module. (Default = 0xFFFFFFFC)
Network Auto Boot Enable [Y/N] = N?
Y The ROMboot function is enabled.
N The ROMboot function is disabled. (Default)
Y ROMboot is attempted at power-up only. (Default).
N ROMboot is attempted at any reset.
Y VMEbus address space, in addition to the usual areas of memory,
will be searched for a ROMboot module.
N VMEbus address space will not be accessed by ROMboot.
(Default)
Y The Network Auto Boot (NETboot) function is enabled.
N The NETboot function is disabled. (Default)