Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 48)

PPCBug Firmware
MVME51005E Single Board Computer Installation and Use (6806800A38D) 50
NVRAM Bootlist (GEV.fw-boot-path) Boot Enable [Y/N] = N?
Note: When enabled, the GEV boot takes priority over all other boots, including Autoboot and
Network Boot.
NVRAM Bootlist (GEV.fw-boot-path) Boot at power-up only [Y/N] = N?
NVRAM Bootlist (GEV.fw-boot-path) Boot Abort Delay = 5?
The time (in seconds) that a boot from the NVRAM boot list will delay before starting the boot.
The purpose for the delay is to allow you the option of stopping the boot by use of the BREAK
key. The time value is from 0-255 seconds. (Default = 5 seconds)
Auto Boot Enable [Y/N] = N?
Auto Boot at powerup only [Y/N] = N?
Y Give boot priority to devices defined in the fw-boot-path global
environment variable (GEV).
N Do not give boot priority to devices listed in the fw-boot-path
GEV. (Default)
Y Give boot priority to devices defined in the fw-boot-path GEV at
powerup reset only.
N Give powerup boot priority to devices listed in the fw-boot-path
GEV at any reset. (Default)
Y The Autoboot function is enabled.
N The Autoboot function is disabled. (Default)
Y Autoboot is attempted at powerup reset only.
N Autoboot is attempted at any reset. (Default)