Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 109)

Pin Assignments
MVME51005E Single Board Computer Installation and Use (6806800A38D) 111
6.3.6 VMEbus P1 & P2 Connector Pin Assignments (SBC Mode)
The VMEbus connector P1 provides power and VME signals for 24-bit address and 16-bit data.
The pin assignments for the connector are specified by the IEEE P1014-1987 VMEbus
Specification and the VME64 Extension Standard.
Row B of connector P2 provides power to the MVME5100 and to the upper 8 VMEbus address
lines and additional 16 VMEbus data lines.
Rows A, C, Z and D provide power and interface signals to the MVME712 or MVME761
transition module in SBC mode (also called 761 mode and IPMC mode).
It is important to note that the PMC I/O routing to row D and Z are not the same as
MVME2600/2700. The PMC I/O routing for row D and row Z is the same as the PMC mode with
the exception of pins Z1, 3, 5, 7, 9, 11, 13, 15 and 17 which are used for extended SCSI.
Note: A PMC card installed in slot 2 of an MVME5100 in SBC mode MUST NOT connect to J24-
2, 5, 8, 11, 14, 17, 20, 23 and 26 since they are connected to the extended SCSI signals of the
MVME5100.
The pin assignments for the P2 connector using the IPMC761 or the IPMC712 are listed in the
following two tables:
Pin Row Z Row A Row B Row C Row D
1 DB8# DB0# +5V RD-
(10/100) PMC2_1 (J24-1)
2 GND DB1# GND RD+
(10/100) PMC2_3 (J24-3)
3 DB9# DB2# RETRY# TD-
(10/100) PMC2_4 (J24-4)
4 GND DB3# VA24 TD+
(10/100) PMC2_6 (J24-6)
5 DB10# DB4# VA25 Not Used PMC2_7 (J24-7)
6 GND DB5# VA26 Not Used PMC2_9 (J24-9)
7 DB11# DB6# VA27 +12VF PMC2_10 (J24-10)
8 GND DB7# VA28 PRSTB# PMC2_12 (J24-12)
9 DB12# DBP# VA29 PRD0 PMC2_13 (J24-13)