Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 31)

Hardware Preparation and Installation
MVME51005E Single Board Computer Installation and Use (6806800A38D) 33
Note: This procedure assumes that you have read the user’s manual that was furnished with the
PMCspan, and that you have installed the selected PMC modules on your PMCspan according
to the instructions provided in the PMCspan and PMC manuals.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an electrical
ground. Note that the system chassis may not be grounded if it is unplugged. The ESD
strap must be secured to your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power off and remove the AC
cord or DC power lines from the system. Remove chassis or system cover(s) as necessary
for access to the VME module.
Figure 1-4 PMCspan16E-010 Installation on a PMCspan16E-002