Artesyn MVME51005E SBC Installation and Use (July 2014) - Manual (Page 32)

Hardware Preparation and Installation
MVME51005E Single Board Computer Installation and Use (6806800A38D) 34
3. If the Primary PMC Carrier Module and MVME5100 assembly is already installed in the VME
chassis, carefully remove it as shown in Figure Figure 1-3 and place it with connectors P1
and P2 facing you.
4. Remove four screws (Phillips type) from the standoffs in each corner of the primary PCI
expansion module.
5. Attach the four standoffs from the PMCspan-010 mounting kit to the PMCspan-002 by
screwing the threaded male portion of the standoffs in the locations where the screws
were removed in the previous step.
6. Place the PMCspan-010 on top of the PMCspan-002. Align the mounting holes in each
corner to the standoffs and align PMCspan-010 connector P3 with PMCspan-002
connector J3.
7. Gently press the two PMCspan modules together and verify that P3 is fully seated in J3.
8. Insert the four screws (Phillips type) through the holes at the corners of PMCspan-010 and
into the standoffs on the primary PMCspan-002. Tighten screws securely.
Note: The screws have two different head diameters. Use the screws with the smaller heads on
the standoffs next to VMEbus connectors P1 and P2.
1.3.4 MVME5100
Before installing the MVME5100 into your VME chassis, ensure that the jumpers are configured
properly. This procedure assumes that you have already installed the PMCspan(s) and any
PMCs that you have selected.
Perform the following steps to install the MVME5100 in your VME chassis:
Dangerous voltages, capable of causing death, are present in this equipment. Use extreme
caution when handling, testing and adjusting.