Artesyn ATCA-F125 Installation and Use Guide (April 2014) - Manual (Page 84)

Functional Description
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J) 84
4.10 AMC Bay
The ATCA-F125 provides one AMC bay to support a processor AMC as an application processor.
The slot is connected by an AMC type B+ connector and supports a midsize single width PrAMC
module with access to an on board SATA drive and to a dual gigabit Ethernet controller through
the AMC.
Some PrAMC modules support 10Gb XAUI or 1Gb SGMII channels on ports 8-11 while other
PrAMCs will have PCI Express channels on ports 8-11. The ATCA-F125 has high speed signal
multiplexers to support routing of the AMC port 8-11 signals depending on the PrAMC
installed.
The ATCA-F125 also routes AMC ports 4-7 as a x4 PCIE port directly to a BCM5709s dual
MAC/PHY controller.
The ATCA-F125 provides current limiting power control to the AMC. A hot swap control device
is used to control the 12 V payload power and 3.3 V management power to the AMC as well as
providing current limiting.
SFPP-CO-RJ-45-3M 74752-1301 Molex 3 m direct attach copper
SFP+ cable
Table 4-5 Tested SFP+ Modules (continued)
Artesyn Embedded
Technologies Part
Number
Vendor Part Number Vendor Description