Artesyn ATCA-F125 Installation and Use Guide (April 2014) - Manual (Page 15)

Chapter 1
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J) 15
Introduction
1.1 Features
The ATCA-F125 is a hub board as defined in PICMG 3.0 Revision 3.0 Advanced TCA Base
Specification and PICMG 3.1 Revision 1.0 Specification Ethernet/Fiber Channel for AdvancedTCA
Systems. It supports several Base and Fabric Channel Ethernet interfaces to the Zone 2
backplane. It also supports 1 Gb and 10 Gb Ethernet uplinks to the front panel and to a Rear
Transition Module (RTM) through the Zone 3 connector.
Broadcom Ethernet switches and PHYs are used for the base and fabric channels. The entire
board is managed by a Freescale P2020 QorIQ Integrated Processor.
The ATCA-F125 has several optional features including a processor AMC, local storage and
Telecom clocking.
See the list below for some of the key features of the ATCA-F125:
 Single slot ATCA form factor (280 mm x 322 mm)
 Freescale P2020 QorIQ Integrated Processor for the on board service processor functions
 Two DDR3 memory DIMM slots each of which can support up to 2 GB of DDR3 SDRAM with
ECC
 2 GB default configuration
 2 GB embedded USB Flash module for User Flash memory
 Onboard SATA connector for an optional drive with selectable interface to either the
service processor or the processor AMC
 Real time clock
 RJ-45 UART Console interface to service processor on front panel
 RJ-45 10/100/1000 BaseTx Ethernet Management port on the front panel for P2020 QorIQ
Integrated Processor
 Single USB port on front panel for P2020 processor
 Broadcom BCM56334 managed switch device for the Base Channel to provide 24 ports of
Gigabit Ethernet and four 10G XAUI ports with two 10G uplink channels on the front panel
 Broadcom BCM56820 managed switch device for the Fabric Channel to provide 24 10G
XAUI ports and four 1G SGMII ports with two 10G uplink channels on the front panel