Artesyn ATCA-F125 Installation and Use Guide (April 2014) - Manual (Page 30)

Hardware Preparation and Installation
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J) 30
2.5 Blade Configuration
There are no configuration switch settings for normal operational mode. Switch changes are
for activating various debug modes. Setting any switched to the ON state may cause
unpredictable operation.
2.5.1 SATA Drive Installation
An optional SATA drive may be installed on the ATCA-F125. An 80GB drive designed for
extreme temperature and vibration environments has been test and approved for use on the
ATCA-F125. Contact your Artesyn Embedded Technologies sales representative and order the
HDD-80G-SATA kit which includes the hard drive, all the required mounting hardware, and the
installation instructions.
2.6 Blade Installation and Removal
The blade is fully compatible to the AdvancedTCA standard and is designed to be used in
AdvancedTCA shelves.
Product Malfunction
 Switches marked as “reserved” may carry production-related functions and can cause
the product to malfunction if the setting is changed.
 Do not change settings of switches marked as “reserved”.
Product Damage
 Setting/resetting the switches during operation can cause damage to the product.
 Check and change switch settings before installing the product.
Product Damage
 Too much force may damage the reset switch.
 Use minimal force when pressing the reset switch.