2 sas/sata connector, 3 embedded usb connector, 2 sas/sata connector 3.7.3 embedded usb connector – Artesyn ATCA-F125 Installation and Use Guide (April 2014) User Manual
Page 61: Table 3-19, J11 sas/sata connector pin assignment, Table 3-20, P8 eusb header pin assignment, Controls, leds, and connectors
Controls, LEDs, and Connectors
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J)
61
3.7.2
SAS/SATA Connector
The following table shows the pinout assignment for the SAS/SATA connector. The board only
supports SATA drives.
3.7.3
Embedded USB Connector
The ATCA-F125 contains a 10-pin 2mm header for an embedded USB module. The following
table shows the pinout assignment for the eUSB header.
Table 3-19 J11 SAS/SATA Connector Pin Assignment
Contact Number
Description
Contact Number
Description
P1
NC
S1
GND
GE21
NC
S2
DRIVE_RX+ (input)
P3
NC
S3
DRIVE_RX- (input)
P4
GND
S4
GND
P5
GND
S5
DRIVE_TX- (output)
P6
GND
S6
DRIVE_TX+ (output)
P7
+5V
S7
GND
P8
+5V
S8
NC
P9
+5V
S9
NC
P10
GND
S10
NC
P11
NC
S11
NC
P12
GND
S12
NC
P13
NC
S13
NC
P14
NC
S14
NC
P15
NC
Table 3-20 P8 eUSB Header Pin Assignment
Contact Number
Description
Contact Number
Description
1
+5V
2
No Connect