Artesyn ATCA-F125 Installation and Use Guide (April 2014) - Manual (Page 69)

Functional Description
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J) 69
4.4 IPMI
The IPMI function on ATCA-F125 is implemented using the Artesyn Embedded Technologies
common ATCA base IPMI design. This building block is based on the Pigeon Point Systems IMPI
implementation using the Renesas HD64F2166 microcontroller which is part of the H8S
controller family. The IPMI building block implementation provides the following features:
 Two IPMB interfaces to the back-plane
 One local IPMB interface for onboard IPMI
 One I2C/IPMB interface for intelligent or non-intelligent RTMs
 One private I2C interface for non-intelligent I2C devices
 Serial UART (SIPL) and KCS/LPC interfaces to the P2020 service processor
 Analog voltage sensor inputs
 Service processor boot flash fail over selection
 Watch-dog timer