Artesyn ATCA-F125 Installation and Use Guide (April 2014) - Manual (Page 32)

Hardware Preparation and Installation
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J) 32
1. Visually inspect the blade and backplane connectors for damage or bent pins before
attempting to insert a board. If any connector damage or pin damage in observed, stop
before inserting the blade and send the damaged item through proper repair channels.
2. Ensure that the top and bottom ejector handles are in the outward position by squeezing
the lever and the latch together.
3. Insert blade into the shelf by placing the top and bottom edges of the blade in the card
guides of the shelf. Make sure that the guiding module of shelf and blade are aligned
properly.
4. Apply equal and steady pressure to the blade to carefully slide the blade into the shelf until
you feel resistance. Continue to gently push the blade until the blade connectors engage.
5. Squeeze the lever and the latch together and hook the lower and the upper handle into the
shelf rail recesses.