Battery exchange – Artesyn ATCA-F125 Installation and Use Guide (April 2014) User Manual

Page 118

Text mode
Original mode

Battery Exchange

ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J)

118

Replacement Procedure

To replace the battery, proceed as follows:

1. Remove the battery. See

Figure 3-2

for location.

Install the new battery following the "positive" and "negative" signs.

PCB and Battery Holder Damage



Removing the battery with a screw driver may damage the PCB or the battery holder. To
prevent this damage, do not use a screw driver to remove the battery from its holder.

This manual is related to the following products:

ATCA-F125 Installation and Use Guide (August 2014) ATCA-F140 Installation and Use (July 2014) ATCA-F140 Installation and Use (May 2014) ATCA-F140 Installation and Use (June 2014) ATCA-F140 Installation and Use (September 2014)