Artesyn ATCA-F125 Installation and Use Guide (April 2014) - Manual (Page 16)

Introduction
ATCA-F125 (6873M Artwork) Installation and Use (6806800J94J) 16
 Multiple 1 GbE SGMII and 10 GbE XAUI ports routed to Zone 3 connectors for base and
fabric uplink channels on RTM
 Stratum 3 and Stratum 3ETelecom clock options with master/slave sync and five inter-shelf
sync connectors on front panel along with 2 BITS/SSU front panel connectors
 Synchronous Ethernet support
 One AMC bay for application processor support
 IPMC functionality for the board management by the Shelf Management Controller
1.2 Standard Compliances
This blade, when installed in a compliant shelf, meets the following standards.:
Table 1-1 Standard Compliances
Standard Description
UL/CSA No. 60950-1
EN 60950-1
IEC 60950-1 CB Scheme
UL/CSA No. 60950-1 Legal safety requirements
ANSI T1.319-2002
NEBS GR-63-CORE ANSI Fire Spread Criteria
AT&T Document ATT-TP-76200 Network Equipment Power, Grounding, Environmental,
and Physical Design Requirements
ETSI Acoustic Noise ETS 300 753
Class 3.1 ETSI acoustic noise requirements
ETSI Stationary Use: EN 300 019-2-3
Class 3.1 ETSI stationary use requirements (temperature-
controlled locations
ETSI Storage EN 300 019-2-1 Class
1.2 ETSI storage requirements in system level (not
temperature- controlled storage locations)
ETSI Transportation: EN 300 019-2-2
Class 2.3 ETSI public transportation requirement on system level
Telcordia GR-1089 Ports and Iitra-building lightning for telecommunication
port