Doremi ShowVault / IMB - Manual (Page 231)

____________________________________________________________________________________
SHV.OM.001663.DRM Page 231 of 276 Version 1.7
Doremi Labs
21 Appendix A: Chase Mode
Using specific software, firmware, and DLM (Doremi License Message), the ShowVault and IMB
can be configured to chase timecode. This section outlines the necessary software and
firmware versions as well as how to configure the ShowVault and IMB in Chase Mode.
21.1 Required Software, Firmware, and License
For the ShowVault and IMB to support Chase mode, it must have the following software and
firmware. To acquire the software, firmware, and DLM, please contact
[email protected] .
For instructions on updating the software and firmware, consult the ShowVault and IMB
manuals.

IMB:
◦ SM Version: 5.1.4 and above
◦ Firmware: 32.07d and above

ShowVault:
◦ Software: 2.6.3
The software and firmware versions can be checked in the About window on the ShowVault
GUI.
In addition to the previously mentioned software and firmware, the ShowVault also
requires the Chase Mode DLM package. To acquire a Chase Mode DLM package, please
contact
[email protected] .

For instructions on ingesting the DLM package, please consult the ShowVault User
Manual, which can be accessed on doremilabs.com .
21.2 Procedure
There are two possible configurations for a Chase Mode setup:
Master and Slave
– One IMB is the master unit which feeds timecode to one slave unit and the
slave unit chases the master. This configuration allows for the synchronization of two IMBs
(Figure 306).
Figure 306: Master Slave Block Diagram
Master Unit Slave Unit
Time Code:
Master Out to
Slave In