EXFO IQS-8500 Series for IQS-600 - Manual (Page 95)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 81
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
To create an EtherSAM (Y.1564) or RFC 2544 Dual Test Set test
case, first create the test on the remote module as follow:
1. Test configuration:
1a. Select
Ethernet 10/100/1000 or
Ethernet 10G as the
Interface Type. Interface
Type is not available with
IQS-8510G.
1b. Select Single Port as the
Topology. Topology is only
available with IQS-8510B.
1c. Select EtherSAM (Y.1564)
or RFC 2544 as the Application Type.
1d. Select the Dual Test Set check box to enable the control of a
remote compatible module (IQS-8510B, IQS-8510G,
IQS-8525/IQS-8535, IQS-8120NGE/IQS-8130NGE, or
RTU-310/RTU-310G). For IQS-8510B, Dual Test Set is only
available in Single Port Topology. This setting is not selected by
default.
1e. Select the Remote test Mode.
1f. Type an ID for this remote unit. Up to 16 characters are allowed.
1g. For IQS-8120NGE and IQS-8130NGE, select the latency
measurement mode; Round-Trip or One-Way. For more
information, refer to Latency Measurement on page 303 for
RFC-2544, or Latency Measurement on page 329 for EtherSAM.
1h. Press Next.