EXFO IQS-8500 Series for IQS-600 - Manual (Page 167)

Port Tabs
Ethernet and Fibre Channel Application 153
Network
For IPv6:

Displays the Link-Local IPv6 Address, Global IPv6 Address, and
Default Gateway Address.

IPv6 Config button allows to configure the IPv6 addresses. Refer to
IPv6 Address Configuration on page 487 for more information.
Frame Format

Frame Format allows to select Ethernet II or 802.3 SNAP frame
format.

OUI is available when the frame format 802.3 SNAP is selected and it
allows the selection of the Organizationally Unique Identifier (OUI).
Choices are RFC1042, and 802.1H. The OUI selection is not coupled
when the Coupled to stream check box is selected.
MPLS
MPLS settings are only available when MPLS is enabled from the test setup
and allow to transmit and receive management frames (ex: PING) inside a
core MPLS network.

Label TX and RX: Allows the selection of the interface MPLS TX and
RX labels (0 to 1048575). The default label value is 16 for both TX and
RX. The TX and RX labels are available when the MPLS check box from
the test setup is selected.
PBB-TE
PBB-TE settings are only available when PBB-TE is enabled from the test
setup and allow to configure the interface source and destination
parameters allowing to exist on a PBB-TE network. Refer to PBB-TE
Interface configuration on page 483 for more information.