EXFO IQS-8500 Series for IQS-600 - Manual (Page 102)

Creating and Starting a Test Case
88 FTB-8500 Series and FTB-8120NGE/8130NGE
Ethernet EtherSAM (Y.1564) and RFC 2544 Dual Test Set Test Cases
2. For additional configuration parameters, refer to EtherSAM Tabs on
page 325 or RFC 2544 Tabs on page 299.
3. On the local module, press the Start button to start the test. The Start
button will be available only when the connection between the two
IQS-8500 Series and IQS-8120NGE/8130NGE units is established.
At least one of the test procedures (For EtherSAM (Y.1564): Service
Configuration Test or Service Performance Test; For RFC 2544:
Throughput, Back-to-Back, Frame Loss or Latency) has to be enabled
to start the test. Test procedures that are enabled will be performed
following this order:
Service Configuration Test and Service Performance Test for
EtherSAM (Y.1564)
Throughput, Back-to-Back, Frame Loss, and Latency for RFC 2544.
4. For additional results, refer to EtherSAM Tabs on page 325 or RFC 2544
Tabs on page 299.