EXFO IQS-8500 Series for IQS-600 - Manual (Page 91)

Creating and Starting a Test Case
Ethernet and Fibre Channel Application 77
EtherSAM (Y.1564) Test Case
4c. Select the Frame Format. Choices are Ethernet II and
802.3 SNAP. For 802.3 SNAP, select the Organizationally Unique
Identifier (OUI). Refer to Network on page 150 for more
information.
4d. Select the PBB-TE check box to enable the capability to generate
and analyze streams with PBB-TE data traffic including
configuration of B-MAC (source and destination), B-VLAN and
I-tag, and to filter received traffic by any of these fields. PBB-TE is
a software option and needs to be enabled to give access to the
PBB-TE testing capability (refer to Software Options on page 380).
PBB-TE is not available when the MPLS check box is selected.
Refer to PBB-TE Interface configuration on page 483 for more
information.
Select the MPLS check box to enable the capability to generate
and analyze streams with up to two layers of MPLS labels and to
filter received traffic by MPLS label or COS. MPLS is a software
option and needs to be enabled to give access to the MPLS testing
capability (refer to Software Options on page 380). MPLS is not
available when the PBB-TE check box is selected. Refer to MPLS
Configuration on page 499 for more information.TX and RX:
Allows the selection of the interface MPLS TX and RX labels (0 to
1048575). The default label value is 16 for both TX and RX. The
TX and RX labels are available when the MPLS check box is
selected. Refer to Network on page 150 for more information.
4e. Set the IP Version (IPv4 or IPv6). IP Version is only available
when the IPv6 software option (SK-IPV6) is enabled.
4f. For IPv4, select the Automatic IP Address check box to
dynamically obtain an IP address from a DHCP (Dynamic Host
Configuration Protocol) server or set the source and destination IP
addresses, Subnet Mask, and the Default Gateway. Refer to IPv4
Configuration on page 485 for more information.