EXFO IQS-8500 Series for IQS-600 - Manual (Page 82)

Creating and Starting a Test Case
68 FTB-8500 Series and FTB-8120NGE/8130NGE
Introducing the Test Setup
Introducing the Test Setup
The Test Setup window is displayed by default when the SUI is started. In
the case where the SUI is not in the test setup window, press the Test
Setup tab from the TEST Tab on page 38.

Tree allows seeing the configuration test structure (data path).

Grid is used for test case direction (decoupled test mode).

Data Path Selector is used to select the datapath structure (for
example: port, signal, Pattern, etc.) of the test case.

Configuration section allows parameters configuration for each node
of the test.
Test Name represents the name of the test connection used to identify
the test. The default setting is TEST.
Note: The other configuration section parameters are described for each specific
test.
Data Path
Selector
Configuration
section
Test Setup
Controls