EXFO IQS-8500 Series for IQS-600 - Manual (Page 343)

EtherSAM Tabs
Ethernet and Fibre Channel Application 329
Overview (Configuration)
Latency Measurement
Note: Available with IQS-8120NGE and IQS-8130NGE modules in Dual Test Set
mode only.
Latency Measurement Mode: Allows to select either Round-Trip (default)
or One-Way as the latency measurement mode.
The one-way latency timestamp is synchronized with an external 1PPS
clock. One-Way latency is only possible when both the local and remote
1PPS signal clocks are valid. The following alarms are available with
One-Way latency measurement mode.
LOPPS-L and LOPPS-R (Loss Of Pulse Per Second - Local/Remote) is
declared when either no pulse is received or when no pulse is received
within 1 second ± 6.6 μs after the previous pulse. LOPPS-R is only
monitored once the DTS connection is established.
Sub-Tests Duration

Service Configuration Test displays the Service Configuration Test
duration in days:hours:minutes:seconds format based on Services,
Ramp, and Burst settings (see Services (Configuration) on page 331,
Ramp (Configuration) on page 337, and Burst (Configuration) on
page 339).

Service Performance Test sets the Service Performance Test
duration in days:hours:minutes:seconds format. The default setting is
10 minutes.