EXFO IQS-8500 Series for IQS-600 - Manual (Page 23)

Ethernet and Fibre Channel Application 9
3 Getting Started
If the Ethernet and Fibre Channel Application has been purchased at the
same time as the IQS-600, the Ethernet and Fibre Channel Application
module is pre-installed with the appropriate IQS Manager software version.
IQS Manager Installation
The IQS Manager is the baseline software and thus needs to be installed on
the IQS-600 before using the Ethernet and Fibre Channel Application
module.
Note: Refer to the IQS-600 platform user guide for more information on IQS
Manager installation procedure.
Inserting and Removing Test Modules
Note: Refer to the IQS-600 platform user guide for more information on how to
insert a module into the IQS-600 or to remove a module from the IQS-600.
Turning the Unit On
Turn on the IQS-600. Refer to the IQS-600 platform user guide for more
information.
C
AUTION
Never insert or remove a module while the controller unit and its
expansion units are turned on. This will result in immediate and
irreparable damage to both the module and unit.