EXFO VDSL2 - Manual (Page 90)

Multi-meter Tests
82 AXS-200/635i
Multi-meter
³
Noise Metallic
³
Longitudinal Balance
³
Dialer
To view Multi-meter test tabs:
From the Multi-meter pane use the F1, F2, or F3 key to view the various
tabs. To view any available additional tabs, use the function arrow keys on
either side of the F1 and F3 keys.
Voltage
The Voltage tab shows measured volts
for each lead combination and allows
you to measure AC/DC voltages and
Frequency on tip, ring, and ground
(A/B/Earth).
Each parameter is described below.
³
Input Impedance displays the
input impedance in the loop. The
available choices are: >1 MOhm,
100 KOhm.
³
Connection defines the type of cable connection to be tested, as
specified in Regional Settings.
To start/stop the test:
1. Press the up/down arrow keys to highlight the desired test parameter.
2. Press to open the list.
3. Press the up/down arrow keys to highlight the desired value, then press
to select it.
4. Select other parameters as required.
5. Press to start/stop the test.
Test results are displayed on the screen as they are completed.