EXFO VDSL2 - Manual (Page 225)

Copper, VDSL2, ADSL2+ and IP Triple-Play Test Set 217
14 Data Analysis
The purpose of the Data Analysis test function is to have the unit act as a
DSL modem allowing you to connect from your computer to the internet
via the unit’s Ethernet port. The unit will display the connected DSLAM
parameters as well as bandwidth utilization, statistics for the IP traffic, and
the different protocols detected as you send and receive information.
To view the available tabs:
Press the left/right function arrows on each side of the F1, F2, and F3 keys.
Reading Results
Test Summary
The Test Summary tab allows you to view the PASS/FAIL status and
Details of the different tests. If a measured value is out the thresholds
configured in the data analysis setup, or if the WAN/LAN connection was
not completed successfully, the Test Summary pane will display a FAIL
message.
The available test results are the
following:
³
Line Status displays Booting,
Activate, Handshaking,
Full Initialization to Connected
for the particular line connection
under test.
³
WAN Status displays whether the
unit is Connected to the wide area
network, or in idle mode.
³
LAN Status displays if the unit is Connected to the local area network.
³
IP Packets provides a summary of the total amount of data received
(being addressed to) and sent by a specific device on the local
network.