EXFO VDSL2 - Manual (Page 136)

Wideband Tests
128 AXS-200/635i
Impulse Noise Test
Impulse Noise Test
The wideband impulse noise test allows you to measure impulse noise on
the circuit under test.
Test Setup
The Test Setup tab allows you to configure parameters for the wideband
impulse noise test.
Each parameter on the pane is
described below.
³
Termination defines if the unit
uses normal test impedance
termination or high bridging
impedance when the cable is
active or terminated by other
external equipment. For normal
test termination select
TERMINATED, otherwise select BRIDGING.
³
Termination Impedance defines the impedance of the dummy load
connected to the line. Select one of the following: 100 or 135 Ohm.
³
Noise Filter defines the level of wideband noise filtering. The available
choices are: NONE, 50 kbit, ISDN-E, HDSL-F, ADSL-G, ADSL, ADSL2+,
VDSL, VDSL2-8, VDSL2-12, VDSL2-17, or VDSL2-30.
Note: VDSL2-x filters are only available if VDSL2WB is enabled in the software
options.
³
Threshold(dBm) is the maximum impulse noise level. Specify a value
between -50 and 0 (-40 and 0 if any filter applied).
³
Measurement Time defines the duration of the Impulse Noise test. The
available choices are: 1, 5, 15, or 60 Minutes, or 24 Hours.