beautypg.com

Data rate prediction, Dsl rate – EXFO VDSL2 User Manual

Page 145

background image

Wideband Tests

Copper, VDSL2, ADSL2+ and IP Triple-Play Test Set

137

Data Rate Prediction

Data Rate Prediction

The data rate prediction test is based on measurements of PSD noise and
attenuation. Considering the fact that all estimates are done from the single
end of the loop, the created report will be presented as a prediction with
reasonable probability.

DSL Rate

The DSL Rate tab allows you to configure parameters and view results for
the current loop topology. The data rate prediction (DRP) test displays the
calculated downstream and upstream rates.

Each parameter on the pane is
described below.

³

Annex defines the modes of
available ADSL Annexes from the
ITU standards.

³

A is ADSL service functioning
over POTS.

³

B activates the ADSL
functionality over ISDN.

³

L Mask 1 assumes an increase in ADSL2 range/distance.

³

L Mask 2 also extends the signal reach but can show an
improvement in the upstream data rate.

³

M allows increased upload speeds from 1 Mbps to 3.5 Mbps.
Available only for ADSL2 and ADSL2+.

³

Technology lists the following values: ADSL, ADSL2, or ADSL2+. If
Annex L is previously selected, ADSL2 is automatically set. If Annex M,
ADSL is not available.

This manual is related to the following products: