Echelon LonWorks Router - Manual (Page 112)

Table 22. Router-Specific Network Management Messages
Network Management Message Request Code
Success
Response
Failed
Response
Set Router Mode 0x74 0x34 0x14
Group or Subnet Table Clear 0x75 0x35 0x15
Group or Subnet Table Download 0x76 0x36 0x16
Group Forward 0x77 0x37 0x17
Subnet Forward 0x78 0x38 0x18
Group No Forward 0x79 0x39 0x19
Subnet No Forward 0x7A 0x3A 0x1A
Group or Subnet Table Report 0x7B 0x3B 0x1B
Router Status 0x7C 0x3C 0x1C
Far Side Escape Code 0x7D ― ―
Router-Specific Network Management Messages
This section describes the router-specific network management messages listed
in Table .
Set Router Mode
This message instructs the router to perform one of several router-related tasks:
• The NORMAL option returns the router from the TEMP_BRIDGE mode.
• The INIT_RTR_TABLE option copies all forwarding tables from
EEPROM into the RAM tables for a configured router, or, sets all RAM
tables to flood for a learning router (this is the same action that occurs
after node reset).
• The TEMP_BRIDGE option causes the router to temporarily forward all
messages in the domain (until the next reset or Set Router Mode message
with the NORMAL option).
Note: The standard Set Node Mode message can be used to take the entire
router offline and online.
The Set Router Mode message affects both router sides. This message uses the
Request-Response protocol.
102 Network Management Messages