Echelon LonWorks Router - Manual (Page 107)

5. Initialize the routing tables using the Set Router Mode network
management message.
6. Change the router state on both sides of the router to Configured, on-line
using the Set Node Mode network management message.
Testing Router Installation
After a router has been installed, you can use the Query Status network
diagnostic message to ensure that it is operational. If no response is received,
query all intermediate routers to determine where the fault occurred. If the
router has been installed with OpenLNS CT, use the Test command (described
under “Testing Devices” in the OpenLNS CT User’s Guide) to query router status.
See the description of the Query Status message in the Standard Messages
section for a description of the error codes returned by the Query Status message.
L ON W ORKS Router User’s Guide 97