Line configuration elements, Line configuration elements 94 – Cabletron Systems CSX1000 User Manual
Page 94

USER’S GUIDE
94 CyberSWITCH
datalink add
Allows you to add a data link. The following sample screen shows how a data link is added.
datalink change
Changes an existing data link.
datalink delete
Deletes an existing data link.
ampconf
Allows you to change the AMP port configuration.
L
INE
C
ONFIGURATION
E
LEMENTS
L
INE
N
AME
A 1 to 16 user-defined character string (using all non-blank characters) that identifies the line. Each
line must have a unique name.
L
INE
S
LOT
The slot number assigned to the resource that will terminate this line.
L
INE
P
ORT
The port number of the resource that will terminate this line.
L
INE
I
NTERFACE
T
YPE
For basic rate lines only. Choice of point-to-point or point-multipoint. The point-to-point interface
type is the type most often used in the U.S.; point-multipoint is most often used in Japan.
A
UTO
TEI
For basic rate lines only.The default setting for automatic TEI negotiation is “yes”. For # 5ESS and
DMS100 lines, you should not change the setting. For NTT point-to-point lines, you should disable
the automatic TEI negotiation by answering “no” to the prompt for this feature.
Current LINE Configuration:
id LINE NAME TYPE SLOT PORT
--------------------------------------------------------------------------------
1 LINE.BASICRATE1 BR_ISDN 1 1
2 LINE.BASICRATE2 BR_ISDN 1 2
3 DMS100.LINE1 BR_ISDN 2 1
Select line id for new data link or press
Automatic TEI negotiation (Y or N) [default = Y]? N
TEI value [default = 1]?
Service Profile ID (enter 0 for no SPID)
[default = NO SPID]? 13135551212
Directory number [default = 13135551212]? 5551212
Number of digits to verify [default = 7]?
The DATALINK configuration has been updated successfully.