Cabletron Systems CSX1000 - Manual (Page 451)

Workgroup Remote Access Switch 451
S YSTEM M ESSAGES
System Message Summary
L
The Network sent a Layer 2 frame with a control field error. This is typically an
unimplemented frame.
M
The Network sent a Layer 2 frame with an illegal Info field.
N
The Network sent a Layer 2 frame with an incorrect length.
O
The Network sent a Layer 2 frame that was too long.
U
The Network sent a Layer 2 frame with a control field error. Typically an unknown frame.
File Access Err
System unable to access file. Check for one of the following log error messages:
Error opening file
Error reading file , section =
Error opening file , slot
Read 0 bytes from file for WAN card in slot
Failure during read of file for WAN card in slot
Error closing file , slot
Error closing password data file
Error opening password data file
Failure on closure of file
Failure opening file
Failure on file closure
Failure on write of file
If you see any of these log messages repeatedly, there may be a problem with the file system.
Contact your Distributor or Customer Support.
Formatting Flash Memory.....
The user has either requested the Flash to be formatted or a corrupted Flash File System was
detected while attempting to save an upgrade/installation file set (transferred via X-Modem).
[FR_IETF] Authentication Failure of remote device NAME
[FR_IETF] Off-Node Authentication Failure of remote device NAME
The device database does not contain an entry for the device specified by NAME. Reconfigure
either the PVC name or the device name so that they match.
[FR_IETF] detected PPP protocol from "NAME", shutting down PVC
FR_IETF has detected a configuration mismatch between the system and the remote device NAME.
The administrator must change the PVC configuration on one of the devices.
Frame Relay event queue full
Indicates a lack of system resources to handle the level of traffic being experienced. Contact your
Distributor or Customer Support.