Cabletron Systems CSX1000 - Manual (Page 411)

Workgroup Remote Access Switch 411
P ROBLEM D IAGNOSIS
Call Detail Recording
If there are no problems with actions 1 and 2, proceed to action 3.
3. Check for the following system messages:
For BRI resource:
In - proceeding <#,#>
In - disconnect <#,#> -
For PRI resource:
In - accept <#,#>
In - disconnect <#,#> -
If the system reports these messages, then the network disconnected the call attempt. For the
disconnect cause meaning, refer to the
Cause Code table. If help is necessary to resolve the
reported disconnect cause, write down the “disconnect cause” and call your phone company
(carrier) to report the problem.
C ALL D ETAIL R ECORDING
Problem:
The
cdr verify command fails for an off-node server.
Action:
1.
Ping the syslog server to check the IP route from the CyberSWITCH to the server. (Note that an
IP route to the server must be established.) If RIP is needed to establish the route, the route may
not be available until the CyberSWITCH has been running for a minute or two.)
2. Using the dr command, check the CyberSWITCH Report log for error messages.
3. Check that the syslogd daemon is running on the syslog server. This can be done with your
UNIX system’s process status (ps) command. This command should result in a display of the
syslogd process. If none is displayed, syslogd is not running.
4. Syslogd can be run in debug mode with the “-d” option. See your UNIX system documentation
for more information on your syslogd daemon process.
5. If syslogd is running but does not receive any log messages, make sure CDR is configured for
the UDP port that syslogd is using. The typical port is 514, but some versions of syslogd may
use a different port.
6. Check that the priority value that you assigned in the CFGEDIT Call Detail Recording menu
(default of 38) matches the priority setting on your syslog server (default of auth.info).