Cabletron Systems CSX1000 - Manual (Page 539)

Workgroup Remote Access Switch 539
S YSTEM C OMMANDS
IP Routing Commands
/dnnnn
Optional parameter that indicates the data size in bytes for the ICMP Echo message. The valid
range for the data size value is 0 to 2020. The default value is 0.
Possible Results and their meanings:
ddd.ddd.ddd.ddd is alive
The valid ICMP Echo Reply was received from host ddd.ddd.ddd.ddd.
No response from ddd.ddd.ddd.ddd
No response was received from the host within the timeout value number of seconds.
ip rip interface
Displays information pertaining to the interface data that is maintained by the IP RIP protocol.
The example screen below illustrates the interface information that will be displayed when this
command is entered.
ip rip routes
Displays information pertaining to the routing table(s) that are maintained by the IP RIP
protocol. The following example screen illustrates the output from this command. Following
the table is an explanation of the fields displayed for each route.
[System Name]> ip rip interface
Status: Active
I/F Type: LAN
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Broadcast Address: 192.168.1.255
Transmission: Version 1
Reception: Version 1 or Version 2
Query Response: Version 1
Version 2 Authentication: Password
Status: Inactive
I/F Type: WAN - UNNUMBERED
IP Address: 0.0.0.0 (left.CSX)
Subnet Mask: N/A
Broadcast Address: 255.255.255.255
Host Route Propagation: N/A
Status: Inactive
I/F Type: WAN - NUMBERED
IP Address: 192.168.3.5
Subnet Mask: 255.255.255.0
Broadcast Address: 255.255.255.255
Host Route Propagation: When host connected